Wet-area diagnostics

Shower & wet-area diagnosis

A damp patch beside a bathroom has two very different explanations: a pipe defect, or failed waterproofing letting shower water past the membrane. The repair paths, and their costs: differ enormously, so a wet-area diagnosis runs controlled tests to attribute the water before anyone quotes anything.

Scope

What this covers

  • Flood testing the shower base with the drain sealed

  • Isolated spray testing of walls, screens and niches

  • Dye testing to distinguish waste-water paths from supply leaks

  • Moisture readings tracked across the test sequence

Timing

When it's needed

Ordered when a ceiling below a bathroom stains, tiles drum or lift, or an ensuite wall stays damp between uses. Especially useful in apartments, where membrane failures are common and responsibility can hinge on precisely what failed.

If escaping water reaches switchboards, power points or light fittings, keep people clear and isolate power at the main switch only if it is safe to reach. Shut water off at the meter stop tap, and treat any sagging, water-laden ceiling as a collapse risk rather than something to prod.

Quote variables

What shapes the scope

In NSW, repairs to water services and sanitary plumbing must be performed by the holder of a plumbing licence or certificate issued through NSW Fair Trading. Detection surveys inform that work rather than replace it: check the licence of whoever carries out the repair, and note that Sydney Water requirements apply to anything at or near the meter connection.

Detection methods

Start your quote

Send through the job details and we'll connect you with a licensed provider who can quote this work.

If this is an emergency or anyone is at immediate risk, contact the relevant emergency service or your network or utility operator directly instead of using this form.